How do I put another wire in?

I want to run a single wire from the dashboard through the firewall into the engine compartment. No matter how hard I look, I cannot find any suitable gaps/apertures where I can wiggle a wire through. Any suggestions out there? It's starting to drive me up the wall.:angry2:

If you have a look behind your accerlerator peddle and follow the throttle cable along you will see where it passes through the firewall/bulkhead. I have found this the easiest way of passing stuff through in the past. Nearby is a conduit,, this is a little harder to use but there should be a few unused ways through in that general area. Just be careful no to let anything get in the way of the brake peddle.

I found a nice big hole in the firewall on the passenger side of mine that came out just behind the glove box. Just make a hole in the sound deadening and the cable will pop through easily, reach up behind the glove box and pull.

I assume it is quite safe to cut one of the nipples of one of these rubber hedgehogs. I have found one not far down from the fuse box but it is in an awkward position to get at - i haven't had a look from the footwell yet to see what's in there. Thanks for all your help. I'm confident of being able to get the wires through now.

i use the grommet on the passenger. I didn't realise there was one on the drivers side as well, thanks for that i can start filling that one up now its getting a struggle to fit any more thru lol